![]() ![]() Support for remembering the size and position of the main window. I prefer to use the program maximized or with a larger window. But on each run it opens to some apparently fixed, smaller size.ģ. * The 'File imported successfully' dialog that is displayed after importing an external sound file.Ībility to turn off some of the forced confirmation dialogs. #ALPINESOFT VINYLSTUDIO SOFTWARE PROFESSIONAL#.#ALPINESOFT VINYLSTUDIO SOFTWARE SOFTWARE#.#ALPINESOFT VINYLSTUDIO SOFTWARE MANUAL#.Then you can add metadata unique to each track. Then right click and copy to all (remaining) tracks. Enter metadata common to all tracks in the first track metadata area. You may want it for CD Text if you burn CD. You probably want good metadata for digital release. Split track at cursor (left click, "split track at cursor" or add a shortcut key - I assigned Ctrl+Shift+T)Įdit metadata if desired. Press Tab key to move to start of next event Place cursor anywhere in first event (LP song) Once events (LP songs) are arranged as desired add track markers: It might be easier if you delete unwanted audio (events) before splitting LP songs. Set cursor to each LP song start and split (not split track) - Alt X (also split unwanted audio).ĭelete any unwanted audio and move events so ends snap together (keyboard "L" toggles snap). Record the LP (all songs, both sides) as a single Studio One "song".Ĭreate project (including updating mastering file). When the full power of Studio One to refine each song is not needed I have found it convenient to move to a Project immediately after recording as follows: Garry, Thanks for the useful information. You'll find we're mostly friendly and helpful here so if you have any problems just ask away. Repeat for all tracks.Īnd welcome to the forums. Choose the format and bitrate you require, set the output filename and folder, and make sure the Export Range is set to Between Loop. ![]() Find the end of the album track and Alt+Click (Option+Click on a Mac) to set the Loop End marker. To do this, set the Loop Start marker at the left hand point on the track: Ctrl+click (Cmd+click on a Mac) on the timeline above the track to set the loop start. Now you can go through saving each album track separately if you want to. Save the entire recording somewhere suitable. ![]() Play some of it back to make sure it sounds OK. When finished, press the Stop button (the blue square) on the Transport Bar. When you're ready, click the Record button on the Transport Bar (the filled circle at the bottom of the window to the right of the Play button) and start your album playing back. Play the album and check the level on the track 1 meter drag the gain slider up or down to suit.Ĭlick the Record Arm button on the track header (the white circle to the right of M and S at the top-left of the window). Click Mix (bottom right-hand corner) to bring up the console the channel for your track is the one on the far left and the Master channel is over on the right.Ĭlick the Monitor button on the track header (the half-filled circled to the left of where it says 'Track 1') at the top-left of the window. On the Track menu, click Add Audio Track (stereo). It doesn't matter if you set the Song Length too short as Studio One will expand the timeline if necessary when you're recording. Make sure it's set to 44.1KHz sample rate with a resolution of 24 bit and set Song Length to approximately the length of the album, and click OK. You'll need to record an album as one entire piece and then split it up if you want to, so click Create a New Song from the start page. You'll need to point Studio One at your line input go to Options, Audio Setup - it's similar to the way you set up Audacity. ![]()
0 Comments
Leave a Reply. |